Orifice Control Within the Converter, Part 1

Part One of a Three-Part Series

One of the more frequently asked torque converter questions is about the .028" orifice (Figure 1) found in some General Motors298mmand300mmTCC pistons with carbon weave lining.

Converter rebuilders want to know why some of the pistons have the orifice and some do not. The answer to this question begins with understanding why the orifice was used in the first place. The orifice was drilled through the piston to help cool the mass of the converter. The TCC release passage is open to exhaust when the converter is in the TCC apply mode. Metered oil, which is allowed to bypass the piston by way of the orifice, carries some heat away from the converter.

The Original Equipment Manufacturer (OEM) later discovered that the loss of clamping force, caused by the leakage through orifice, was not worth the extra cooling gain. For this reason the orifice is being phased out of production and will not be in new models. The TCC pistons in some foreign converters also had a similar orifice, but only in a limited number of applications. Today, the best approach for a rebuilder is to close the orifice with a small tig weld (Figure 2)。

Another popular torque converter question is about the three .185" diameter holes (Figure 3) in the 300mm turbines.

Rebuilders often ask why they are found in the 300mm turbines and not in the 298mm turbines. To answer that question, you need to know how the lockup function differs between the two converters. In the 298mm converters, the turbine hub comes into contact with the conical washer which is in contact with the cover. In this type of converter, the TCC piston is free to move forward and backward for lockup apply and release, independently of the turbine hub. In the 300mm converter, the turbine hub is not held in a fixed position relative to the cover. In this type of converter, the small gaps at the end of the vanes provide asecondary path for balance oil (Figure 4)。这条路不是在300毫米转换器因为开放se their turbines are furnace brazed, which closes the holes (Figure 5)。The three .185" holes provide the secondary oil path. Keep this in mind the next time you are using a furnace brazed turbine to build a performance converter. You may want to add a few holes to balance forward thrust.

The amount of oil needed to balance the thrust loads on the turbine seems to be fairly consistent. The three .185" holes in the 300mm turbine will pass about 26.8 GPM at 80 PSI at 180°F. The four .165" holes in the Allison 1000 converters will pass 28.4 GPM under the same conditions. A similar amount of oil was able to pass through the gaps at the end of the vanes on the 298mm turbines.

Don't missPart 2which covers the holes that allow oil to pass through the stators and turbine hubs.

Ed Lee is a Sonnax Technical Specialist who writes on issues of interest to torque converter rebuilders. Sonnax supports theTorque Converter Rebuilders Association.