6L80/6L90 "No Movement" After Repair

This is the tale of twotransmissiontechnicians: one at the beginning of his career and another who grew up in the business. What they have in common is working on the6L80/6L90for the first time. Both were doing repairs: one had installed updated seals for an intermittent 2-3 flare, while the other installed an upgraded clutch pack. They both had the same question: what would cause a "no-move" Forward or Reverse after the rebuild? Even though they each had a different cause, both were the result of simple mistakes or "traps" which can easily be overlooked.

Problem #1

Retaining Ring Pop-Out

安装后,单位在第一,但是suddenly lost Forward, then after a few more minutes, it lost Reverse. The Service Fast Learn (SFL) process with the scanner would abort halfway through the process.

When the unit was disassembled, it was discovered the 1-2- 3-4 clutch retaining ring had popped out of its groove. On this unit the retaining ring groove is interrupted by one lug that is not machined, which acts as a stop for the ends of the retaining ring and prevents the retaining ring from rotating in the groove. The open end of the ring should straddle the special unmachined lug.

The reason for the retaining ring pop-out was that the technician did not notice the special unmachined lug, and when the retaining ring was placed over this area, the retaining ring was prevented from fully seating in the groove. It only took a short test drive for the ring to pop out, creating the no-move condition.Figure 1shows a similar un-machined lug for the upper 3-5 Reverse retaining ring, whileFigure 2shows the retaining ring properly installed.

---

Problem #2

SFL Process Failure & No Engagement

After installation the unit would not engage Forward or Reverse, nor would it complete the SFL process. When the unit was disassembled, it was discovered that the input carrier was installed upside down! This prevented the 1-2-3-4 housing splines from engaging the input carrier and resulted in no move, Forward or Reverse.

Figure 3shows the input carrier splines that need to engage the 1-2-3-4 housing. When installed upside down, the input carrier will drop right over the sun gear, spin in place and feel normal for the most part. It’s amazing that a major hard part like the input carrier can be installed upside down and have no effect on assembly or endplay.

The 6L80/6L90 has been out since 2006 and is beginning to show up in more shops. Overall, it is an easy transmission to work on, but whether you are a novice or an old timer, be sure to avoid these two “traps” waiting to catch you.